2005 LR3 SE V8 - Replaced rear rotors, pads and sensors. Everthing went fine. During test drive I am hearing a faint scraping noise. It's intrmittent and does not happen while braking and brakes are working properly. Checked both rear wheels for debris and saw nothing. Cleaned all parts carefully before re-assembly. Any thoughts on what it could be or if I missed something?
Did you replace any of the hardware? I.E (not sure on the LR3) springs clips or related pins? Did you grease any of the slide points? Did the breaks come with the anti squeal backing and did you use it or any such thing?
__________________ This forum is not used much... please go to:
When working with GEMS vehicles. Never try to locate a misfire by pulling plug leads off - pull the injector connector instead. Otherwise you can blow up the ECU.
Secondly never swap ECUs between vehicles to test them, because both vehicles and ECUs may stop working, and you'll have to have them all reset by a franchised LR dealer (ouch!).
Noise After Rear Brake Service
Redneck Rover
Redneck Rover
Hybrid Mode
