Go Back   Land Rover Forum > Land Rover Specific Models > Discovery I
Register Garage All Albums FAQ Community Calendar Today's Posts Search

Discovery I Discuss here about the first version of Land Rover Discovery (Disco I) in this section.


Reply
 
Thread Tools Display Modes
Old 11-16-2011, 04:11 PM   #1
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default 97 disco wont fire

ive got a 97 disco i can not get to start, i have to pull fuel pump fuse under hood turn key itll start. i put back in fuse itll stay running, its like it floods itself out when i first go to start vech. ive changed plugs, wires, cps(crankshaft position sensor) idle air control sensor, fuel pump and cleaned injectors and changed coil pack........ive been working on this truck for 3 days straight and nothing.....any answers or clues!!!??

Last edited by younggun88; 11-16-2011 at 04:23 PM.
younggun88 is offline   Reply With Quote
Old 11-16-2011, 04:11 PM   #2
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

and theres no codes
younggun88 is offline   Reply With Quote
Old 11-16-2011, 04:22 PM   #3
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

just replaced the maf sensor as well.......same prob
younggun88 is offline   Reply With Quote
Old 11-16-2011, 05:57 PM   #4
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

i have also just noticed tht it will start with acc pedal all the way to the floor then cut back off.....need suggestion im running out of ideas fast!!
younggun88 is offline   Reply With Quote
Old 11-16-2011, 07:02 PM   #5
Joey
Senior Member
 
Join Date: Mar 2011
Location: Liberty Twp, OH
Posts: 225
Garage
Default

How many miles?

When was the last time you changed the fuel filter?

How old is the fuel pump?

Have you test fuel pressure?

What type of plugs are you using and how old/miles are on them?
__________________
This forum is not used much... please go to:

http://www.landroverworld.org


Joey
Cincinnati OH
http://www.customroveraccessories.com Home of the New D2 horn buttons!

http://www.usarovers.com/ (call for Rover parts ask for Nathan 502-222-5859)

Rover Radio issues or IPOD Adapters http://home.valornet.com/splacket/index.htm

EAS fault http://www.rswsolutions.com

When working with GEMS vehicles. Never try to locate a misfire by pulling plug leads off - pull the injector connector instead. Otherwise you can blow up the ECU.

Secondly never swap ECUs between vehicles to test them, because both vehicles and ECUs may stop working, and you'll have to have them all reset by a franchised LR dealer (ouch!).
Joey is offline   Reply With Quote
Old 11-16-2011, 07:11 PM   #6
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

165k miles, changed fuel pump 11/14/11, fuel filter changed 11/14/11, fuel pressure is at 38psi, plugs changed 11/15/11 champion plugs
younggun88 is offline   Reply With Quote
Old 11-16-2011, 07:13 PM   #7
Joey
Senior Member
 
Join Date: Mar 2011
Location: Liberty Twp, OH
Posts: 225
Garage
Default

How long does it take for the fuel pressure to leak off after it is pressurized?
__________________
This forum is not used much... please go to:

http://www.landroverworld.org


Joey
Cincinnati OH
http://www.customroveraccessories.com Home of the New D2 horn buttons!

http://www.usarovers.com/ (call for Rover parts ask for Nathan 502-222-5859)

Rover Radio issues or IPOD Adapters http://home.valornet.com/splacket/index.htm

EAS fault http://www.rswsolutions.com

When working with GEMS vehicles. Never try to locate a misfire by pulling plug leads off - pull the injector connector instead. Otherwise you can blow up the ECU.

Secondly never swap ECUs between vehicles to test them, because both vehicles and ECUs may stop working, and you'll have to have them all reset by a franchised LR dealer (ouch!).
Joey is offline   Reply With Quote
Old 11-17-2011, 09:07 AM   #8
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

over night it dropped down....
younggun88 is offline   Reply With Quote
Old 11-17-2011, 09:16 AM   #9
Joey
Senior Member
 
Join Date: Mar 2011
Location: Liberty Twp, OH
Posts: 225
Garage
Default

I am sure you have tried this, but disconnect the battery for an hour or so to see if it resets the ECU... also does it have any OBDII codes?
__________________
This forum is not used much... please go to:

http://www.landroverworld.org


Joey
Cincinnati OH
http://www.customroveraccessories.com Home of the New D2 horn buttons!

http://www.usarovers.com/ (call for Rover parts ask for Nathan 502-222-5859)

Rover Radio issues or IPOD Adapters http://home.valornet.com/splacket/index.htm

EAS fault http://www.rswsolutions.com

When working with GEMS vehicles. Never try to locate a misfire by pulling plug leads off - pull the injector connector instead. Otherwise you can blow up the ECU.

Secondly never swap ECUs between vehicles to test them, because both vehicles and ECUs may stop working, and you'll have to have them all reset by a franchised LR dealer (ouch!).
Joey is offline   Reply With Quote
Old 11-17-2011, 10:33 AM   #10
younggun88
Junior Member
 
Join Date: Nov 2011
Age: 36
Posts: 9
Garage
Default

i will disconnect batt. as of right now, no codes. but before i cleared codes i had 6 codes, as follows: 1193, 0181, 0116, 0125, 0118, 1193.......i am going to cut an rerun wires for the CPS now while batt is disconnected. thx for the help so far
younggun88 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:53 PM.


Sponsor Ads

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

Garage vBulletin Plugins by Drive Thru Online, Inc.