Go Back   Land Rover Forum > Land Rover Specific Models > Discovery I
Register Garage All Albums FAQ Community Calendar Today's Posts Search

Discovery I Discuss here about the first version of Land Rover Discovery (Disco I) in this section.


Reply
 
Thread Tools Display Modes
Old 07-12-2013, 01:44 AM   #1
kleener
Junior Member
 
Join Date: Jul 2013
Age: 66
Posts: 1
Default 1997 Auto Disco won't crank

3.9 V8Australian delivery with 4 speed auto.

While working in some rough country a fortnight ago, I stopped the Discovery, went back and could not get it to crank. Hauled it out from where it was with a tractor and shifted it about 500 m to safe level ground.

I suspected a faulty safety interlock switch or wiring, so bypassed that and ran a wire to the solenoid, which enabled me to start the car beautifully.

Unfortunately even with the engine running there is a bad case of fail to proceed, and no movement in any gear - there is a slight noise if it revs are not allowed to drop right back before re engaging park, which sounds like the locking pawl scraping on a moving shaft.

Any suggestions?

The car does not owe a great deal and I can probably recoup my investment by scrapping it, but it is a handy vehicle so if is an easy fix, would like to try that first.
kleener is offline   Reply With Quote
Old 07-12-2013, 08:17 AM   #2
Joey
Senior Member
 
Join Date: Mar 2011
Location: Liberty Twp, OH
Posts: 225
Garage
Default

Check the transmission linkage to ensure that it is getting into gear. I would also check the transfer case linkage to make sure it isn't in neutral as well.
__________________
This forum is not used much... please go to:

http://www.landroverworld.org


Joey
Cincinnati OH
http://www.customroveraccessories.com Home of the New D2 horn buttons!

http://www.usarovers.com/ (call for Rover parts ask for Nathan 502-222-5859)

Rover Radio issues or IPOD Adapters http://home.valornet.com/splacket/index.htm

EAS fault http://www.rswsolutions.com

When working with GEMS vehicles. Never try to locate a misfire by pulling plug leads off - pull the injector connector instead. Otherwise you can blow up the ECU.

Secondly never swap ECUs between vehicles to test them, because both vehicles and ECUs may stop working, and you'll have to have them all reset by a franchised LR dealer (ouch!).
Joey is offline   Reply With Quote
Reply

Bookmarks

Tags
v8 auto discovery, won't crank, won't engage gears


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:55 AM.


Sponsor Ads

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

Garage vBulletin Plugins by Drive Thru Online, Inc.